Rinse Aid - Zanussi DE 4944 Instruction Book

Rinse aid

Rinse aid is automatically added during the last rinse, ensuring
thorough rinsing, and spot and streak free drying.
The dispenser, which is positioned inside the door, holds about
110 ml of rinse aid, which is sufficient for 16 - 40 dishwashing
programmes, depending upon the dosage setting.
Filling with rinse aid
1. Open the container by pressing the release button (A).
2. Add the rinse aid until the container is completely full. The
maximum level for filling is indicated by "max".
BR07
Ensure that the lid is closed after every refill.
Clean up any rinse aid spilt during filling with an
absorbent cloth to avoid excess foaming during the next
wash.
Only use branded rinse aid for dishwashers. Never fill the
rinse aid dispenser with any other substances (e.g.
dishwasher cleaning agent, liquid detergent). This would
damage the appliance.
Adjusting the dose
According to the finish and drying results obtained, adjust the
dose of rinse aid by means of the 6 position selector (position
1 minimum dosage, position 6 maximum dosage).
The dose is factory set in
position 4.
Increase the dose if there are
drops of water or lime spots
on the dishes after washing.
Reduce it if there are sticky
whitish streaks on the dishes
or a bluish film on glassware
or knife blades.
Top up the rinse aid when the indicator light on the control
panel illuminates.
BR14
BR09
If you are using dishwasher detergent that already contains
rinse aid, it is necessary to deactivate the inflow of rinse aid,
in order to avoid a double dosage.
To deactivate the inflow of rinse aid,
proceed as follows:
(The dishwasher must be switched off)
When the inflow of rinse aid has been deactivated, the
rinse aid indicator light on the control panel is
automatically deactivated.
1. Press the On/Off push button. The On/off indicator light
illuminates.
If other push button indicator lights are on, this means that
a wash programme has been selected. The programme
must be cancelled: press simultaneously the function push
buttons 2 and 3 for about 2 seconds. All the indicator lights
will turn off (except for the On/Off indicator light).
2. Press simultaneously function push buttons 2 and 3, until
the indicator lights of the function push buttons 1, 2 and 3
start flashing.
3. Press the function push button 2, the indicator lights of
function push buttons 1 and 3 turn off while the indicator
light of the function push button 2 goes on flashing, at the
same time the end of programme indicator light illuminates
indicating that the inflow of rinse aid is active.
4. To deactivate the inflow of rinse aid, press the function push
button 2 again, the end of programme indicator light turns
off, indicating that the inflow of rinse aid has been
deactivated.
5. To memorise the operation, switch off the dishwasher by
pressing the On/Off push button or wait about 60 seconds
after which the dishwasher will automatically return to
setting mode.
To activate the inflow of rinse aid follow the above instructions
until the end of programme indicator light illuminates.
9