Golden Technologies GA 541 Owner's Manual page 26

Avenger Owner's Manual
ASSEMBLING YOUR AVENGER
Additional Steps to Re-assembling your Avenger™:
Once you've joined the front and rear components and connected the ball
detent pin, you must:
1. Install the battery pack in the proper location.
2. Connect the motor, brake, battery and charger connections.
3. Replace the battery cover.
4. Install the seat.
5. Position the tiller. WARNING: Make sure you tighten your tiller to be
sure it is locked!
6. Unlock your front wheel lock knob. WARNING: If you do not unlock the
lock knob, the tiller will not turn. This can lead to a failure to turn when
operating your Avenger™.
Revised 09/29/09
™
Notice how the front
component connects easily to
the rear component.
Step 3:
Connect the ball detent pin.
Make certain the ball detent
pin is fully installed and
tightened.