Adding The Chorus Effect To The Tone; Using The Metronome - Casio PX-350M User Manual

Adding the Chorus Effect to
the Tone
1.
While holding down the
button, press the dl
This will display a chorus type selection screen.
2.
(w, q) buttons to select the
Use the ct
chorus type you want.
• The following shows the five available chorus type
settings.
0: OFF (no chorus)
1: Light Chorus
2: Chorus
3: Deep Chorus
4: Flanger
3.
Press the cs (FUNCTION) button.
This exits the chorus type selection screen.
cs (FUNCTION)
(CHORUS) button.

Using the Metronome

1.
Press the 3 (METRONOME) button.
This will start the metronome.
Lights with the first beat
of each measure
2.
Press the 3 (METRONOME) button again to
stop the metronome.
Changing the Beats Per Measure
You can specify from two to six beats per measure for
the metronome. After you do, a chime will sound at the
beginning of each measure. Specifying 0 for this setting
will sound a straight beat, without a chime. This setting
lets you practice with a steady beat.
1.
Hold down the 3 (METRONOME) button
until the number of beats per measure screen
shown below appears on the display.
2.
ct (w, q) buttons to select the
Use the
beats per measure value you want.
3.
3
Press the (METRONOME) button to exit
the number of beats per measure screen.
Using Built-in Tones
Lights with each
subsequent beat of
each measure
E-13