Zanussi ZWT 12120 User Manual page 10

Top-loading washing machine
Table of Contents

Advertisement

10 How to run a wash cycle
"Extra rinse" option
The washing machine will add one or
more rinses during the cycle.
This option is recommended for people
with sensitive skin and in soft water
areas.
Temporary :
Press the "Extra rinse" pushbutton. The
option is only active for the selected pro-
gramme.
Permanent :
Hold down the "Temperature"
"Option" pushbuttons for a few se-
conds. The option is permanently acti-
vated, even if the appliance is switched
off. To deactivate it, repeat the process.
"Delay start"
This option allows you to delay the start
of a wash programme by 3, 6 or 9 hours
by pressing the "Delay start"
pushbutton.
You can change or cancel the delayed
start time at any time before you press
the "Start/Pause" pushbutton, by pres-
sing the "Delay start"
again (when all indicators are off, the
wash programme will start immediately).
If you have already pressed the "Start/
Pause" pushbutton and you want to
change or cancel the delayed start, pro-
ceed as follows :
• To cancel the delayed start and start
the cycle immediately, press "Start/Pau-
se" and then "Delay start"
"Start/Pause" to start the cycle.
• To change the timer delay period, you
must go through the "Off"
and reprogram your cycle.
The lid will be locked during the delayed
start time. If you need to open it, you
must first pause the appliance by pres-
sing the "Start/Pause" pushbutton. After
closing the lid again, press the "Start/
Pause" pushbutton.
Start of the programme
and
It is normal for the programme selector
to remain stationary during the cycle.
: Prewash + Wash
: Rinse + Spin
: End
Interrupting a programme
Adding washing during the first 10
minutes
Press the "Start/Pause" pushbutton :
pushbutton
the corresponding light will flash green
while the appliance is paused. The lid
can only be opened around 2 minutes
after the washing machine has come to
a stop. Press the "Start/Pause" pus-
hbutton again to continue the program-
me.
. Press
position
Press the "Start/Pause"
pushbutton to start the
cycle ; the corresponding
light will come on green.
The light corresponding
to the current cycle is illu-
minated.

Advertisement

Table of Contents
loading

Table of Contents