Yamaha FZ6-S Owner's Manual page 21

Air intake temperature mode
The temperature displayed may vary
from the outside temperature depend-
ing on engine conditions. To switch the
clock to the air intake temperature
mode, first set the display to the odom-
eter or tachometer mode, and then
push the "RESET" button for at least
two seconds.
Fuel meter
The fuel meter indicates the amount of
fuel in the fuel tank. The display seg-
ments of the fuel meter disappear to-
wards "E" (Empty) as the fuel level
decreases. When only one segment is
left near "E", refuel as soon as possible.
NOTE:
This fuel meter is equipped with a self-
diagnosis system. If the electrical circuit
is defective, the display segments will
flash. If this occurs, have a Yamaha
dealer check the electrical circuit.
Coolant temperature meter
With the key in the "ON" position, the
coolant temperature meter indicates
the temperature of the coolant. When
INSTRUMENT AND CONTROL FUNCTIONS
the key is turned to "ON", all of the dis-
play segments of the coolant tempera-
ture meter will appear one after the
other and then disappear in order to
test the electrical circuit. The coolant
temperature varies with changes in the
weather and engine load. If the top seg-
ment flashes, stop the vehicle and let
the engine cool. (See page 6-37.)
CAUTION:
Do not operate the engine if it is
overheated.
Self-diagnosis devices
This model is equipped with a self-diag-
nosis device for various electrical cir-
cuits.
If any of those circuits are defective, the
engine trouble warning light will come
on, and then the multi-function display
will indicate a two-digit error code (e.g.,
12, 13, 14).
This model is also equipped with a self-
diagnosis device for the immobilizer
system.
3-7
If any of the immobilizer system circuits
are defective, the immobilizer system
indicator light will flash, and then the
multi-function display will indicate a
two-digit error code (e.g., 51, 52, 53).
NOTE:
If the multi-function display indicates er-
ror code 52 (all segments of the coolant
temperature meter will come on, except
ECA10020
the top segment, which will flash), this
could be caused by transponder inter-
ference. If this error appears, try the fol-
lowing.
1. Error code display
1. Use the code re-registering key to
start the engine.
3