Advertisement
TO INSERT BATTERIES
Use a Phillips screwdriver
(not included) to loosen
screw in battery
compartment door
(screw remains
attached to door).
Remove door and insert
4 x 1.5V "AA" or LR6 size
alkaline batteries.
Replace door and
tighten screw.
CAUTION: TO AVOID BATTERY LEAKAGE
1. Be sure to insert the batteries correctly and
always follow the toy and battery manufacturers'
instructions;
2. Do not mix old batteries and new batteries or
alkaline, standard (carbon-zinc) or rechargeable
(nickel-cadmium) batteries;
3. Always remove weak or dead batteries from
the product.
2
IMPORTANT: BATTERY INFORMATION
Please retain this information for future reference.
Batteries should be replaced by an adult.
CAUTION:
1. Always follow the instructions carefully. Use only
batteries specified and be sure to insert item
correctly by matching the + and – polarity
markings.
2. Do not mix old batteries and new batteries or
standard (carbon-zinc) with alkaline batteries.
3. Remove exhausted or dead batteries from the
product.
4. Remove batteries if product is not to be played
with for a long time.
5. Do not short-circuit the supply terminals.
6. Should this product cause, or be affected by, local
electrical interference, move it away from other
electrical equipment. Reset (switching off and
back on again or removing and re-inserting
batteries) if necessary.
7. RECHARGEABLE BATTERIES: Do not mix these with
any other types of batteries. Always remove from
the product before recharging. Recharge
batteries under adult supervision. DO NOT
RECHARGE OTHER TYPES OF BATTERIES.
3
Advertisement
