Table of Contents
Advertisement
125987350.qxp
2007-01-09
laundry.
Empty Tank"
l i g ht
"
"
This light indicates that the appliance is in the
.
drying phase
This light comes on at the end of the
programme to remind you that the water
reservoir must be emptied out. If this light
illuminates during a programme this means
that the water reservoir is full. The buzzer
sounds, the programme stops, the light of
the Start/Pause button flashes. This light
comes on also when the water reservoir is
not inserted correctly.
"Filter" light
This light illuminates at the end of the
programme to remind you that the
filters must be cleaned.
"Condenser" light
It comes on every 80 cycles to remind you
that the condenser must be cleaned.
Cancelling a programme
Turn the selector dial to
a programme which is running. Now
you can select a new programme.
At the end of the programme
If the laundry is not removed at the end
of the cycle, the dryer performs an
creasing
phase (duration: 30 minutes
maximum).
If you do not remove the laundry, the
dryer will stop automatically at the
end of the anti-creasing phase.
Lights End/Anticrease, Filter and
Condenser remain lit and the buzzer
sounds for 2 minutes.
Turn the programme selector dial to
to switch the machine off. Remove the
laundry from the drum and carefully
check that the drum is empty.
If you do not intend to carry out another
15:02
Page 11
wash, close the water tap. Leave the
door open to prevent the formation of
mildew and unpleasant smells.
After each use
• Clean the filters.
• Empty the water reservoir.
Important!
If the drying programme has to be
stopped before it reaches the end, we
recommend that you turn the pro-
gramme selector dial to position Cooling
and wait until the end of this cooling
"Off"
phase before removing the laundry. This
to cancel
will avoid a build-up of heat inside the
appliance.To do this first turn the dial to
Off
"
Start button.
Modifying the programme
anti-
To change a programme which is run-
ning, first cancel it by turning the pro-
gramme selector dial to "
new programme and press the Start
button .
"Off"
use electrolux 11
Turn the programme selector dial to
Off
"
"; all the lights go out. The appli-
ance is switched off.
Remove the laundry.
If you open and then close the door
before turning the selector dial to
"Off" all the lights corresponding to
the phases making up the performed
programme come on.
" and then to Cooling and depress
Off
GB
". Select the
Advertisement
Table of Contents
