Handlebar Switches - Yamaha YFM35FGX Owner's Manual

EBU17952
On-Command four-wheel-drive indicator light
" "
This indicator light comes on when the On-Com-
mand four-wheel-drive switch is set to the "4WD"
position.
NOTE:
Due to the synchronizing mechanism in the differ-
4
ential gear case, the light may not come on until
the ATV starts moving.
EBU18061

Handlebar switches

1. Light switch " /
2. Engine stop switch "
3. Start switch " "
/OFF"
/ "
EBU18080
Engine stop switch "
Set this switch to "
The engine stop switch controls the ignition and
stops the engine when it is running. Use this switch
to stop the engine in an emergency situation. The
engine will not start or run when this switch is set
to " ".
EBU18100
Start switch " "
Push this switch to crank the engine with the start-
er.
ECB00050
CAUTION:
See the starting instructions on page 6-1 prior
to starting the engine.
EBU18151
Light switch "
Set this switch to "
and the taillight. Set the switch to "
the high beams and the taillight. Set the switch to
"OFF" to turn off all the lights.
4-3
/ "
" before starting the engine.
/ /OFF"
" to turn on the low beams
" to turn on