Rear Wheel - Yamaha TT-R 110 Owner's Manual

Rear wheel

To remove the rear wheel
WARNING
G It is advisable to have a Yamaha
dealer service the wheel.
G
Securely support the motor-
cycle so that there is no danger
of it falling over.
1. Disconnect the brake torque rod
from the brake shoe plate by re-
moving the cotter pin, the nut and
the bolt.
1. Brake torque rod
2. Cotter pin
3. Brake torque rod bolt and nut
4. Brake shoe plate
PERIODIC MAINTENANCE AND MINOR REPAIR
EAU25080 2. Remove the brake pedal free play
adjusting nut, and then disconnect
the brake rod at the brake cam-
EAU41642
shaft lever.
EWA10820
1. Brake rod
2. Brake pedal free play adjusting nut
3. Brake camshaft lever
4. Wheel axle
3. Loosen the locknut and the drive
chain slack adjusting nut on both
ends of the swingarm.
1. Axle nut
2. Washer
3. Drive chain slack adjusting nut
4. Locknut
4. Loosen the axle nut.
5. Lift the rear wheel off the ground
6. Remove the axle nut and washer,
7. Push the wheel forward, and then
6-30
1
2
according to the procedure on
page 6-28.
and then pull the wheel axle out.
remove the drive chain from the
rear sprocket.
3
4
6