Table of Contents
Advertisement
5. Intensive programme light
This pilot light comes on when the most energetic pro-
gramme is selected (no. 2 INTENSIVE) with hot pre-
wash, suitable for pans and particularly dirty crockery,
to remind you that this programme requires an extra
dose of detergent (about 1 tablespoon) to be placed
in the WRD dispenser. Follow the dosing instructions
in the "Wash Programme" chart on the following
pages.
6. Economy Drying
When this button is pressed, the last rinse water is
heated up to 55°C, with a significant saving in electri-
cal energy. The corresponding pilot light comes on.
If the pilot light is not on the water of the last rinse
will always be heated up to 65°C.
7. Delayed Start
button
Allows the start of the programme to be delayed by a
minimum of 1 hour, up to 9 hours.
How to set the delayed start
When the button is pressed, the number
in the display (3).
Press the button again to select the number of hours
by which you wish to delay the programme start, up to
a maximum of 9.
E.g.: if you have selected number
gramme will start in 2 hours time.
To cancel the delayed start set, press the button until
the number
appears.
Close the dishwasher door to start the countdown: a
long audible signal (about one second) informs you that
the function is active.
If you open the door again you will see, in the display
(3), how long there is to go (in hours) before the
programme starts. A flashing dot in the digital display
means that the delayed start function has been activated.
Opening the door has no effect on a countdown which
has already been started.
If, during the countdown, you wish to see the pro-
gramme number selected in the display, press the
Programme Selector button (4).
If, after having started the countdown by closing the
dishwasher door, you wish to cancel the delayed start,
press the Cancel button
(8) for about 2 seconds
until the short «instruction accepted «signal is heard».
button
appears
, the wash pro-
PPC25GB
25
8. Cancel / programme change
If you wish to cancel a programme which is already
running or a setting which has just been made, press
this button for about two seconds until the short
«instruction accepted» signal is heard.
The number
for the first selectable programme
(Rinse and Hold) reappears in the display whilst the
programme selector light (4) flashes, to indicate that
the dishwasher has been reset and that a new
programme and new options may be selected.
button
Advertisement
Table of Contents
