Something Not Working - Zanussi ZWA 5110 Instruction Manual

Something Not Working

Many checks have been carried out during the manufacture of your washing machine. However, if you
face a problem with its operation, please read the following sections before calling the After Sales
Service.
The washing machine will not start or will not
fill
The washing machine fills up but empties
again immediately
The washing machine will not spin or will not
empty
There is water on the floor around the
washing machine
Washing results are not satisfactory
The washing machine stops during a washing
cycle
Symptom
- the washing machine is not correctly connected,
the electrical installation is not working
- the cover of your washing machine and the
drum flaps are not correctly closed,
- you did not control the program start correctly
- there is a power failure,
- the water supply is closed off,
- the water tap is closed,
- the water inlet is blocked.
- the drain siphon is attached too low (see
installation part).
- the drain pipe is blocked or kinked,
- the drain filter is blocked,
- the anti-unbalance mass safety device has
tripped; bad distribution of washing in the drum,
- the «Drain» program or the «Rinse hold» option
is selected,
- the height of the drain siphon is wrong.
- excess detergent has made too much foam that
overflowed,
- the detergent is not suitable for washing
machine,
- the drain siphon is not hooked on properly,
- the drain filter was not put back into place,
- the water inlet pipe is leaking.
- the detergent is not suitable for machine
washing,
- there is too much washing in the drum,
- the washing program is not appropriate,
- there is not enough detergent.
- the water or electricity supply is defective,
- a rinse hold was programmed.
- the flaps of the drum door are opened
18
Cause