Table of Contents
Advertisement
To drain the residual water :
Place a shallow container beneath the trap
door. Turn the filter handle anticlockwise until
the filter cap handle is vertical, any residual
water will be released (fig.8).
To clean the filter :
Unscrew the filter anticlockwise and remove
(fig.9).
Clean the filter carefully under a fast running
tap.
Replace the filter and refit by screwing in a
clockwise direction. Close the trap door.
Never remove the water drain filter during
a wash cycle.
Maintenance Wash
With the use of low temperature washes it is
possible to get a build up of residues inside the
drum.
We recommend that a maintenance wash be
performed on a regular basis.
To run a maintenance wash:
•
The drum should be empty of laundry.
•
Select the hottest cotton wash programme.
•
Use a normal measure of detergent, must be a
powder (such a Ariel Futur).
The dangers of freezing
If the machine is exposed to temperatures below
0°C, certain precautions should be taken.
•
Turn off both the water tap.
•
Unscrew the inlet hose.
•
Unhook the drain hose from the rear support
and position the end in a bowl. Run the draining
programme.
To do this:
- Switch the machine on.
- Select a washing programme.
- Press the SKIP/RESET button three times.
- Press START/PAUSE button.
•
Disconnect the appliance.
•
Screw the inlet hose and reposition the drain
hose.
•
When you intend to start the machine up again,
make sure that the room temperature is above
0°C.
fig.8
17
fig.9
Advertisement
Table of Contents
