Page 1
INSTRUCTION MANUAL Cordless Hammer Driver Drill BHP444 BHP454 008997 WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
Wear ear protection ENG203-1 Vibration vibration total value (tri-axial vector sum) For Model BHP444 determined according to EN60745-2-1: ENG102-2 For European countries only Work mode: impact drilling into concrete Noise Vibration emission (a ) : 7.5 m/s h,ID The typical A-weighted noise level determined according Uncertainty (K) : 1.5 m/s...
Do not use any Makita Corporation responsible adapter plugs with earthed (grounded) power manufacturer declare that the following Makita tools. Unmodified plugs and matching outlets will machine(s): reduce risk of electric shock. Designation of Machine: Cordless Hammer Driver Drill Avoid body contact with earthed or grounded Model No./ Type: BHP444,BHP454...
jewellery or long hair can be caught in moving terminals together may cause burns or a fire. parts. 27. Under abusive conditions, liquid may be 16. If devices are provided for the connection of ejected from the battery; avoid contact. If dust extraction collection...
this instruction manual may cause serious personal Let a hot battery cartridge cool down before injury. charging it. ENC007-4 FUNCTIONAL DESCRIPTION IMPORTANT SAFETY INSTRUCTIONS CAUTION: Always be sure that the tool is switched off and the • battery cartridge is removed before adjusting or FOR BATTERY CARTRIDGE checking function on the tool.
when released. When not operating the tool, always set the • To start the tool, simply pull the switch trigger. Tool reversing switch lever to the neutral position. speed is increased by increasing pressure on the switch Speed change trigger. Release the switch trigger to stop. 1.
Page 7
second at the " " position, then stop the tool and Installing or removing driver bit or drill bit slide to your desired position. 1. Sleeve CAUTION: Always set the lever correctly to your desired mode • mark. If you operate the tool with the lever positioned halfway between the mode marks, the tool may be damaged.
Hook Blow-out bulb (optional accessory) 1. Groove 1. Blow-out bulb 2. Hook 3. Screw 008995 002449 The hook is convenient for temporarily hanging the tool. After drilling the hole, use the blow-out bulb to clean the This can be installed on either side of the tool. dust out of the hole.
There is a tremendous force exerted on the tool/bit Use a screwdriver to remove two screws then remove • at the time of hole break through. Hold the tool the rear cover. firmly and exert care when the bit begins to break 1.
Page 10
Only use accessory or attachment for its stated purpose. If you need any assistance for more details regarding these accessories, ask your local Makita Service Center. Drill bits • Hammer drill bits • Screw bits •...
Page 12
Makita Corporation Anjo, Aichi, Japan 884812A223...