Table of Contents
Advertisement
VGA Enable (JPG1)
JPG1 allows the user to enable the
onboard VGA connector (through the
KVM). Close pins 1~2 to enable the
VGA. The default setting is Enabled.
Watch Dog RST/NMI Selection
(JWD1)
Watch Dog (JWD1) is a system moni-
tor that can reboot the system when a
software application hangs. Close pins
1~2 to reset the system if an applica-
tion hangs. Close pins 2~3 to generate
a non-maskable interrupt signal for
the application that hangs. See the
table on the right for jumper settings.
Watch Dog must also be enabled in
the BIOS.
SMB (I
C) Bus to PCI Slots (JI2C1/
2
JI2C2)
Jumpers JI
C1 and JI
C2 allow you to
2
2
connect the System Management Bus
(SMB) to the PCI-E slots. The default
setting is set to Disabled. See the
table on the right for jumper settings.
BMC Enable/Disable (JPB1)
Jumper JPB1 allows you to enable the
embedded BMC (Baseboard Manage-
ment Controller) to provide IPMI 2.O/
KVM support on the motherboard.
See the table on the right for jumper
settings..
Chapter 5: Advanced Motherboard Setup
VGA Enable/Disable
Jumper Settings
Jumper Setting
Pins 1-2
Pins 2-3
Jumper Settings
Jumper Setting
Pins 1-2
Pins 2-3
Open
2
I
Jumper Settings
Jumper
On
Off
Jumper Settings
Pin#
1-2
2-3
5-15
Defi nition
Enabled
Disabled
Watch Dog
Defi nition
Reset
NMI
Disabled
C to PCI-Slots
Defi nition
Enabled
Disabled (Default)
BMC Enable
Defi nition
Enabled (default)
Disabled
Advertisement
Table of Contents
