Using The Remote - RCA TV REMOTE Installation And Operation Manual

TV REMOTE HO SWITCH CONTROLLER
The TV Remote HO Switch
Controller (TVHOSC) system uses
a universal TV remote to control
10 HO turnouts or switches. The
universal TV remote is pictured
below. Press one button to close
the switch and a second button to
open the switch. It is that easy!
The unit is fairly compact and is
pictured to the right. It is mounted
on a small block of wood and will
easily mount on a train layout. A
quarter coin is also shown.
If you want to control more than
10 switches, two controllers can
used together. That is use one
remote to control the two
controllers.

USING THE REMOTE

The remote is a universal type which has
to be configured for a Sony TV. This
means the remote transmits the codes
that a Sony TV would use.
Instructions are included with the remote
to program it for a Sony TV.
To use the remote point it towards the
TVHOSC unit. There is an IR receiver
mounted on the unit. If you examine the
remote you will notice that there are ten
number buttons 0 to 9. Theses ten
buttons are used to first select a switch.
Press a number button to select a switch
first. Then using the Volume buttons.
Press Vol + to open the switch and Vol –
to close the switch.
The Chan + and Chan – are used to
switch the controller between two
systems
There would be a high controller
and a low controller. Select the
high or low controller using the
Channel + or Channel – buttons
respectively.
VOLUME
BUTTONS
NUMBER
BUTTONS
Make sure
the remote's TV button is pressed too.
TV
BUTTON
2