SENDO 300 User Manual page 9

Inserting the battery
Insert the battery into the phone, starting
with the top edge first. Align the tabs on the
edge of the battery with the tabs on the back
of the phone. Make sure the gold-coloured
contacts of the battery are touching the
contacts on the phone. Push down into
place.
If you need to remove the battery, press
down on the tab at the centre of the bottom
edge of the battery and lift out.
ζ
Note: Always turn your phone off before
you insert or remove the battery.
Replacing the back cover
Place the cover onto the back of the phone
and slide the cover into place making sure
the tab at the top of the cover clicks into
place.
Charging the battery
You must charge the battery for at least 12
hours before using the phone for the first
time. After this, the battery will normally take
several hours to charge.
Insert the connector on the charger lead into
the connector on the bottom of the phone.
Plug the charger into a wall socket. When
charging commences, the battery icon will
change into a charger cable icon. When the
battery is fully charged, the battery icon will
reappear and you can disconnect the
charger.
Once you connect the charger, you can
switch your phone on. If the battery is
completely empty, it may take a few minutes
7
3