Table of Contents
Advertisement
MAINTENANCE
1. Clean dirt from the grease fitting (A).
2. Carefully pump grease into fitting (A). DO NOT force
grease. Too much pressure will force grease past seals and
cause damage. Apply 1-2 pumps of grease every 15-25
hours of operation.
3. Wipe excess grease from around grease fitting.
Drive Shaft Assembly
Level 1.
Parts Required:
POWER BLENDX
Grease.
Hedge Clipper blades are very sharp. Touching them may
lead to severe personal injury. Avoid touching blades
whenever possible, and always wear gloves to protect
hands.
1. Remove gear housing locating screw (A) and loosen
clamping screw (B). Remove the gear housing assembly
from the drive shaft housing..
2. Pull the drive shaft (C) from the housing, wipe clean and
re-coat with a thin coating [1/2 oz. (15 ml)] of grease.
3. Slide the drive shaft back in the drive housing being careful
not to get dirt on the flex shaft.
28
TM
14 oz. or Lithium Base
HCA-266
A
A
D
B
A
D
B
X7502026404
© 08/2013 ECHO Inc.
Advertisement
Table of Contents
