Unpacking & Set-Up - Classe Audio DAC-88 Owner's Manual

UNPACKING & SET-UP
The Classé DAC-88 has been carefully wrapped in heavy gauge plastic, packed in semi-rigid
foam and contained in a special box. To remove the unit, open and spread the top flaps of the box. By
its sides, lift out the entire unit with the foam pieces intact. Remove each foam side by pulling straight
out. Remove the plastic wrap and inspect the unit for any concealed damage. Apart from this owner's
manual, please ensure the detachable A.C. linecord has also been included.
Please report any damage or missing parts to your dealer promptly.
The DAC-88 must be located in a position free of any hum-inducing magnetic fields. (This also
applies to turntables and interconnect cables.) Positions adjacent to power amplifiers, A.C. line filters,
or regulation devices should be avoided. Ideally, a few feet should separate the DAC-88 from the power
amplifier. As well, keep low-level interconnect cables away from the power amp and separate from
A.C. line cords.
Heat generated by the processor is negligible. Air space around the unit need not be a concern.
Check the Serial Number sticker on the back of the unit for the correct operating voltage.
Regardless of voltage, the fuse rating should be 3/8 AMP SLO-BLO.
-4-