Connecting Your Flat Panel Speaker Bezel To Your Monitor - IBM 15-inch Flat Panel Monitor Speaker Bezel User Manual

Connecting your flat panel speaker bezel to your monitor

Follow these instructions to connect your speakers to your flat panel monitor,
refer to the illustration for identification.
1 DC power cable (from bezel speaker assembly)
2 DC power plug
3 DC power receptable
4 AC/DC adapter (monitor)
1. Locate the cables on your flat panel monitor speaker bezel. The dc power
cable 1 is hardwired to your speaker bezel.
2. Unplug the ac/dc adapter connector from the monitor. (Remove the back
panels on the IBM T541 monitor before unplugging the ac/dc adapter).
3. Connect the dc power plug 2 to the receptacle connector on the monitor.
See step 6 on page 1-5
4. Route wires as shown. See step 6 on page 1-5
5. Connect the dc power receptacle 3 to the ac/dc adapter plug.
1-4
IBM 15-inch Flat Panel Monitor Speaker Bezel: User's Guide