Front-Panel Controls - Harman Kardon AVR 445 Owner's Manual

AVR 445
B
A
1
NOTE: To make it easier to follow the instructions that refer to this illustration, a larger copy may be downloaded from the Product Support section for this product at
www.harmankardon.com.
The following controls and indicators are available on the AVR 445's front panel:
1 Standby/On Switch
2 Surround Mode Group Selector
3 Surround Mode Selector
4 Tuning Selector
5 Tuner Band Selector
6 Preset Station Selector
The following controls and jacks are located behind the front-panel door. To open the door, place the edge of a finger on the left or right edge of the panel and gently swing the
door down toward you.
A Main Power Switch
B Headphone Jack
C Tone Mode Button
D Speaker Selector Button
E Channel Adjust Selector
1 Standby/On Switch: When the Main Power
Switch A is "ON, " press this button to turn on the
AVR 445; press it again to turn the unit off. Note that
the illumination surrounding the switch will turn blue
when the unit is on, or in the Multiroom mode.
2 Surround Mode Group Selector: Press this but-
ton to select the top-level group of surround modes.
Each press of the button will select one of the sur-
round mode categories. Once the button is pressed so
^ %
$
DIGITAL
PRO LOGIC IIx 57CH. STEREO
HEADPHONE
VIRTUAL SPEAKER DIRECT
DSP
SURR. OFF
C D E F G
2 3
4
7 Input Source Selector
8 Tuning Mode Selector
9 Front-Panel Door
) Volume Control
! Input Indicators
@ Speaker/Channel Input Indicators
F Digital Input Selector
G Delay Adjust Selector
H ‹/› Buttons
I Set Button
J EzSet/EQ Microphone Jack
that the name of the desired surround mode category
appears in the on-screen display and in the Lower
Display Line $, press the Surround Mode
Selector 3 to cycle through the individual modes
available. For example, press this button to select Dolby
modes, and then press the Surround Mode Selector
3 to choose from the various mode options.
3 Surround Mode Selector: Press this button
to select from among the available surround mode

FRONT-PANEL CONTROLS

FRONT-PANEL CONTROLS
# @ !
VID 12 DMP
VID 34 USB
XMFMAM
HDMI TAPE
CDMI 6CH
DVD 8CH
H I H J K
5 6 7
# Upper Display Line
$ Lower Display Line
% Surround Mode Indicators
^ Remote Sensor Window
K Optical 4 Digital Input
L Coaxial 4 Digital Input
M Input/Output Status Indicator
N Video 4 Input/Output Jacks
options for the surround mode category selected.
The specific modes will vary based on the number of
speakers available, the surround mode category and
whether the input source is digital or analog. For exam-
ple, press the Surround Mode Group Selector 2
to select a category such as Dolby or Logic 7, and
then press this button to see the specific mode choices
that are available. For more information on mode
selection, see pages 24, 35 and 58.
)
L M N
8
FRONT-PANEL CONTROLS
9
5 5