Dim Function; Processor Reset; Memory - Harman Kardon HK 3485 Owner's Manual

OPERATION

Dim Function

Some people find the front-panel messages distracting and would prefer
to dim them or turn them off altogether.
To dim the display, press the Dim Button on the front panel or remote.
Each button press will cycle through the three settings of:
VFD FULL: Normal brightness
VFD HALF: Display is dimmed but still visible; the light inside the
volume knob goes dark
VFD OFF: Display goes completely dark except for Power Indicator
to remind you that the receiver is turned on

Processor Reset

If you wish to fully reset the HK 3485 to its factory defaults, or if it
behaves erratically after a power surge, first turn the Master Power
Switch off and unplug the AC power cord for at least three minutes. Plug
the cord back in and turn the receiver back on. If this doesn't help, you
may want to try a system reset.
NOTE: A system reset erases all user configurations, including
tuner presets. After a reset, you will need to re-enter all of these
settings.
Place the receiver in Standby mode by pressing the Power Switch so
that the Power Indicator turns amber. Press and hold the front-panel
Mute Button for at least five seconds until the RESET message appears
in the display.
If the receiver still does not function correctly after a processor
reset, contact an authorized Harman Kardon service center for assis-
tance. Service centers may be located by visiting our Web site at
www.harmankardon.com.

Memory

If the HK 3485 is unplugged or experiences a power outage, it will
retain user settings indefinitely.
24