Table of Contents
Advertisement
Installation
Warning!
Unpacking
Slide out the polythene bag with
the polystyrene stuffing before
using the appliance
Pull off adhesive strips from inside
machine on top of drum.
Should the appliance be moved,
it must be transported
vertically.
Positioning
It is recommended that, for your
convenience, the machine is positioned
close to your washing machine.
The tumble dryer must be installed in a
clean place, where dirt does not build
up.
Air must be able to circulate freely all
round the appliance. Do not obstruct
the front ventilation grille or the air
intake grilles at the back of the
machine.
To keep vibration and noise to a
minimum when the dryer is in use, it
should be placed on a firm, level
surface.
Once in its permanent operating
position, check that the dryer is
28
absolutely level with the aid of a spirit
level. If it is not, raise or lower the feet
until it is.
The feet must never be removed.
Do not restrict the floor clearance
through deep-pile carpets, strips of
wood or similar. This might cause
heat build-up which would interfere
with the operation of the appliance.
Important
The hot air emitted by the tumble dryer
can reach temperatures of up to 60°C.
The appliance must therefore not be
installed on floors which are not
resistant to high temperatures.
When operating the tumble dryer, the
room temperature must not be lower
than +5°C and higher than +35°C, as it
may affect the performance of the
appliance.
Electrical connection
This machine is designed to operate on
a 230 V, single-phase, 50 Hz supply.
Check that your domestic electrical
installation can take the maximum load
required (2.35 kW), also taking into
account any other appliances in use.
Connect the machine to an earthed
socket, in accordance with current
wiring regulations.
The manufacturer declines any
responsibility for damage or
injury through failure to comply
with the above safety
precaution. Should the
appliance power supply cable
need to be replaced, this must
Advertisement
Table of Contents
