Zanussi ZTE278 Instruction Booklet page 23

Malfunction
Loading door does not
close.
When pressing a button,
the corresponding
button flashes several
times.
Drying cycle ends shortly
after programme starts.
END light illuminated.
Drying cycle lasts an
unusually long time.
Note: After around 5
hours the drying cycle
ends automatically (see
„Drying cycle complete")
If you are unable to identify or solve the
problem, contact our service centre.
Before telephoning, make a note of the
model, serial number and purchase date
of your machine: the Service Centre will
require this information.
Possible cause
•Fine strainer not in
place and/or large
mesh filter not locked
in place.
•Washing protection.
After the start of the
programme, the option
can no longer be set.
•Not enough washing
loaded or washing
loaded is too dry for
selected programme.
•Lint filter clogged.
•Heat exchanger
clogged with lint.
•Low temp. button
pressed and load
volume too big.
•Load volume too big.
•Laundry insufficiently
predrained.
Important:
if you call out an engineer to a fault
listed below, or to repair a fault caused
by incorrect use or installation, a charge
will be made even if the appliance is
under guarantee.
Solution
•Install fine strainer
and/or snap large
mesh filter into place.
• Turn the programme
knob to OFF ("O"). Set
the programme again
•Select time programme
or higher drying level
(e.g. Extra droog
instead of Kastdroog).
•Clean lint filter
•Clean heat exchanger.
•Low temp is only
suitable for use with
loads of up to 3 kg!
•Reduce load volume.
•Laundry must be
adequately pre-
drained.
23