Harman Kardon AVR 310 Owner's Manual page 33

Advanced Features
turned off, the semi-OSD displays will remain
activated, even if they were switched off for the
previous listening session.
To change the length of time that the semi-OSD
displays remain on the screen, go to the
Menu as outlined
earlier, and press the buttons
/
needed, until the on-screen cursor is next to
the
press the Buttons 31 until the
/
desired time in seconds is displayed. Note that
unlike most of the other options in this menu,
this is a permanent setting change, and the
time-out entry will remain in effect until it is
changed, even when the unit is turned off.
If you wish to make other adjustments, press
the Buttons until the on-screen
/
cursor is next to the desired setting or the
line and
press the Set button . If you have no other
adjustments to make, press the OSD Button
to exit the menu system.
Full-OSD Time Out Adjustment
The menu system is used to
simplify the setup and adjustment of the
AVR 310 using a series of on-screen menus. The
factory default setting for these menus leaves
them on the screen for 20 seconds after a
period of inactivity before they disappear from
the screen or Time Out. This Time Out is a safety
measure to prevent image retention of the
menu text in your monitor or projector, which
might happen if they were left on indefinitely.
However, some viewers may prefer a slightly
longer or shorter period before the Time Out
display.
To change the Full-OSD Time Out, you will need
to make an adjustment in the
menu (Figure 9). To start the
adjustment, press the OSD button
the main menu to the
screen. Press the button six times,
until the on-screen cursor is next to the
line. Press the Set Button
to enter the
(Figure 9).
At the
(Figure 9) make certain that the on-screen
cursor is next to the
line by pressing the Buttons
/
needed. Next, press the buttons
/
until the desired time is displayed in seconds.
Note that unlike most of the other options in
this menu, this is a permanent setting change,
and the Time-Out entry will remain in effect
until it is changed, even if the unit is turned off.
If you wish to make other adjustments, press
the Buttons
/
as cursor is next to the desired setting or the
line. Next, press the Set button
adjustments to make, press the OSD
button to exit the menu system.
to bring
Menu
menu
as
/
31
until the on-screen
line and
. If you have no other
33 ADVANCED FEATURES