Front Panel Controls - Harman Kardon AVR 2000 Owner's Manual

Front Panel Controls

29
Main Power Switch
System Power Control
Power Indicator
Headphone Jack
Selector Buttons
Tone Mode
Surround Mode Selector
Tuning
Tuner Band Selector
Preset Stations Selector
Main Power Switch: Press this button to
apply power to the AVR 2000. When the switch
is pressed in, the unit is placed in a Standby
mode, as indicated by the amber LED
rounding the System Power Control
button MUST be pressed in to operate the unit.
To turn the unit off completely and prevent the
use of the remote control, this switch should be
pressed until it pops out from the front panel
so that the word "OFF" may be read at the top
of the switch.
NOTE: This switch is normally left in the "ON"
position.
AVR 2000
RDS PTY CT RT
Input Source Selector
RDS Select Button
Digital Optical 3 Input
Digital Coax 3 Input
Video 4 input jacks
Bass Control
Balance Control
Treble Control
Volume Control
Set Button
System Power Control: When the Main
Power Switch is "ON, " press this button to
turn on the AVR 2000; press it again to turn the
sur- unit off (to Standby). Note that the Power
. This Indicator surrounding the switch
green when the unit is on.
Power Indicator: This LED will be illumi-
nated in amber when the unit is in the Standby
mode to signal that the unit is ready to be
turned on. When the unit is in operation, the
indicator will turn green.
Headphone Jack: This jack may be used to
listen to the AVR 2000's output through a pair
of headphones. Be certain that the headphones
have a standard 6.3 mm stereo phone plug.
Note that the speakers will automatically be
turned off when the headphone jack is in use.
TA
RDS
ing the AVR 2000's configuration settings, use
these buttons to select from the choices available,
as shown in the Main Information Display
will turn
disables the Balance, Bass and Treble tone con-
trols. When the button is pressed so that the
words TONE IN appear in the Main
Information Display
Bass
Balance control
nals. When the button is pressed so that the
words TONE OUT appear in the Main
Information Display
will be "flat, " without any balance, bass or treble
alteration.
Input Indicators
Delay
Digital Input Selector
Main Information Display
Channel Select Button
Speaker Select Button
Test Tone Selector
Surround Mode Indicators
Remote Sensor Window
Selector Buttons: When you are establish-
Tone Mode: Pressing this button enables or
, the settings of the
and Treble controls and of the
will affect the output sig-
, the output signal
FRONT PANEL CONTROLS
.
5