Miele T 4859 Ci Operating Instructions Manual page 50

Problem solving guide
Problem
Water leaks from the
dryer after the
condenser unit has
been cleaned.
The display and the
sensors are not lit up
and the Start sensor is
flashing slowly.
The programme does
not start.
The display is in a
different language.
The interior drum
lighting does not
come on.
50
Possible cause
– The inner cover of
the condenser unit
has not been locked
properly and/or the
condenser unit has
not been positioned
correctly.
– Fluff has collected in
the condenser unit
housing.
Standby. To save
energy the display and
sensor illumination
switches off
automatically.
No obvious cause.
A different language
has been selected.
The lighting switches
off automatically (to
save energy).
The lock has been
activated.
Remedy
– Ensure that the condenser
unit is positioned correctly
and lock the inner cover.
– Check the rubber seals.
– Use a cloth to remove any
visible fluff from the inside
of the condenser unit
housing.
– Touch the Start sensor. The
display and sensors will
light up.
– See "Settings".
– Is the dryer switched on?
– Is the plug correctly
inserted into the socket and
switched on?
– Is the door closed
properly?
– Has the fuse or circuit
breaker tripped?
Set the language you want.
The flag symbol
you.
– Switch the dryer off and
then on again.
– If the lamp needs to be
replaced, follow the
instructions in "Changing
the lamp" at the end of this
section.
– Enter the code to
deactivate it and the light
will come on.
will guide