Tricity Bendix SG210 Operating & Installation Instructions Manual page 22

Fixing and use of the 2 clips provided with
the cooker
clip
The enclosed gas hose fixing clips must be
fixed to the back of the cooker, dependant on
the position of the supply bayonet connector
(see fig.).
When selecting the most suitable position for
Clip Position
the clips, please ensure that the gas hose
Options
cannot come into contact with any part of the
"Hot zone" (indicated by the shaded areas on
the illustration) when pushing the cooker into
its final position.
Finally, secure the hose into the clips.
Rigid Connection
Where it is not possible to make the
connection using a rubber hose, a rigid pipe
work connection must be used.
Right angled
bayonet socket
Recommendations when using an appliance
incorporating Distribuitor
pipe
spring loaded
flexible connector are as follows:
Adaptor
valve
backplate
Female
- For NATURAL the gas installation pipes to
Copper pipe elbow
the termination point shall comply with:
Specification for installation of low-
pressure gas pipe work of up to 20mm
(R1) in domestic premises (2nd family gas)
– BS 6891;
Alternative
Connection shall be by means of an
backplate
elbow
appliance flexible connector for use with a
Cooker hose with
self-sealing plug-in device, complying with:
bayonet fixing
Flexible hoses, end fittings and sockets for
gas burning appliances – BS 669;
• The appliance flexible connector should
Cooker hose with
Straight bayonet
not be subjected to undue forces either in
bayonet fixing
socket
incorporating
normal use or whilst connected or
spring loaded
valve
disconnected; The socket which the plug of
the appliance flexible connector fits should be
permanently attached to a firmly fixed gas
installation pipe and positioned such that the
appliance flexible connector hose hangs
freely downwards (see fig.);
22