Assembly; Installing Bagger Mount - Husqvarna MZ54 Operator's Manual

1

INSTALLING BAGGER MOUNT

1. Select the mount tube, lower mount hitch, spacer
plate and support bracket from the kit. Using
/ -18 x 1¾ round head shoulder bolts and
5
16
nuts, attach the mount hitch to the mount tube as
illustrated. Ensure that the elbowed arm of the tube
is on the right side, with the mount hitch installed
to the front.
2. Attach the support bracket to the tube assembly
with two / -18 x 1¾ round head shoulder bolts
5
16
and nuts.
Mount.Tube

ASSEMBLY

Spacer.Plate
Support.Bracket
8063-109
Lower.Mount.Hitch
3. With a ½-13 x 1 hex bolt and nut, secure the lower
mount hitch to the frame.
4. Install the mount straps (bends are to the inside)
on the outside of the mount tube using
hex bolts and nuts. The front side of the mount
straps are secured to the fuel tank brackets with
/ -16 x 1 round head shoulder bolts and nuts.
3
8
5. To prevent contact of the left hand strap and
the EFM (Electronic Fuel Management) box on
the engine, place the foam strip on the inside of
the strap, next to the box. (Illustration location is
approximate.)
6. It may necessary to drill holes into the rear
guard to accept the hardware for the support
bracket and spacer plate. Using the bracket as a
template, drill / " holes.
5
16
7. Slip the spacer plate between the support bracket
and the rear guard and attach both to the rear
guard with / -18 x ¾ hex bolts and nuts.
5
16
8. Tighten all hardware.
Foam.Strip
Mount.Strap
Support.Bracket.and.
Spacer.Plate
/ -18 x 2
5
16
8063-110
Mount.Strap
5