Canadian Programming; Resetting Defaults - Oldsmobile AURORA 2002 Owner's Manual

3. Return to HomeLink in your vehicle and firmly
press and release the programmed HomeLink
button three times.
-
The rolling code garage door opener should now
recognize HomeLink. You may either use HomeLink or
-
the hand held transmitter to open the garage door.
If after following these instructions, you still have
problems training the garage door opener, contact the
manufacturer of HomeLink at 1
or on the internet at www.homelink.com.

Canadian Programming

Canadian Owners: During programming, the
-
hand held transmitter may automatically stop
transmitting after two seconds. In this case, you should
press and hold the HomeLink button (see Steps 2 and 3
under "Programming the HomeLink Transmitter") while
you press and repress (cycle) your hand
every two seconds until HomeLink is trained.
- - -
800 355 3515,
-
held transmitter
Operating the HomeLink Transmitter
Press and hold the appropriate button on HomeLink for
at least a half of a second. The indicator light will come
on while the signal is being transmitted. The trunk
release lockout switch must be OFF.
Erasing Channels
To erase all three programmed channels, hold down the
two outside buttons on HomeLink until the indicator
light begins to flash (approximately 20 seconds).
Release both buttons.

Resetting Defaults

To reset HomeLink to default settings, hold down the
two outside buttons on HomeLink until the indicator
light begins to flash (approximately 20 seconds).
Continue to hold the buttons until the HomeLink
indicator light turns off and then release both buttons.
Accessories
Accessories for HomeLink are available. If you
would like additional information, please contact the
manufacturer of HomeLink at 1
or on the internet at www.homelink.com.
- - -
800 355 3515,
2-65