Honda GX110 Owner's Manual page 26

<Oil bath type>
1. Unscrew the wing nut, remove the air cleaner cover and remove the
element.
2. Wash the element in a solution of household detergent and warm water,
then rinse thoroughly, or wash in nonflammable or high flash point sol-
vent. Allow the element to dry thoroughly.
3. Soak the element in clean engine oil and squeeie out the excess oil.
The engine will smoke during initial start-up if too much oil is left in the
element.
4. Empty the oil from the air cleaner case and wash out any accumulated
dirt with nonflammable or high flash point solvent. Dry the case.
5. Fill the air cleaner case to the level mark with the same oil tha.t is recom-
mended for the engine (see engine oil recommendations on page 7).
6. Reinstall the element and the cover.
AIR CLEANER COVER
ELEMENT
24