Honda GX110 Owner's Manual page 25

<Cyclone type>
1 .Remove the wing nut and the air
SPECIAL PAN SCREW (3)
cleaner cover. Remove the ele-
E-CLEANER CAP
ments and separate them. Care-
fully check both elements for holes
or tears and replace if damaged.
2.Foam element: Wash the element
in a solution of household deter-
gent and warm' water, then rinse
PAPER
ELEMENT
thououghly, or wash in nonflam-
mable or high flash point solvent.
Allow the element to dry thorough-
CYCLoNE
FOAM
ELEMENT
IY-
Soak the element in clean engine
oil and squeeze out the excess oil.
The engine will smoke during initial
start-up if too much oil is left in the
foam.
3. Paper element: Tap the element
lightly several times on a hard sur-
face to remove excess dirt, or blow
compressed air through the filter
from the inside out. Never try to
brush the dirt off; brushing will
force dirt into the fibers. Replace
the paper element if it is excessive-
ly dirty.
4. Cyclone Housing: Remove the
three special pan head screws,
remove the housing, and wash the
components with water. Dry the
components thoroughly, and
carefully reassemble them.
CAUTION:
l
When reinstalling the cyclone housing, be sure that the air intake tab fits
properly into the groove in the pre-cleaner cap.
l
Be careful to install the air guide as shown.
23