Connecting With A Vcr/Component Equipment - Sony VPL-SC50U Operating Instructions Manual

Connecting

Connecting with a VCR/Component Equipment

Right side
1) When both the S VIDEO and VIDEO jacks are connected to the external equipment, the input signal from the S VIDEO jack is selected.
Right side
SMF-402 Signal Cable (not supplied)
3X phono jack ˜ HD D-sub
15-pin (male)
20
(EN)
This section describes how to connect the projector with a VCR, external
active speakers, and component equipment.
For details on how to connect a computer, see page 18 (EN).
Also refer to the instruction manuals of equipment to be connected.
When making connections, be sure to:
• turn off all equipment before making any connections.
• use the proper cables for each connection.
• insert the plugs of the cables properly; plugs that are not fully inserted
often generate noise. When pulling out a cable, be sure to pull it out from
the plug, not the cable itself.
VCR
to S video
1)
output
S-Video cable
(not supplied)
S VIDEO VIDEO
INPUT A
S VIDEO VIDEO
INPUT A
Component equipment
Note
Set the aspect ratio using ASPECT in the INPUT SETTING menu
according to the input signal.
1)
to audio/video outputs
Audio/video cable
(supplied)
L-AUDIO-R
AUDIO OUT
AUDIO IN
MOUSE
L-AUDIO-R
AUDIO OUT
AUDIO IN
MOUSE
Stereo audio
connecting cable
(not supplied)
to component output
Active speakers