Table of Contents
Advertisement
Listening to the radio
Tuning
1
Press the ON/STAND-BY button to turn the power on.
2
Press the TUNER (BAND) button repeatedly to select the desired
frequency band (FM or AM).
3
Press the TUNING/TIME (
or
) button to tune in to the desired
station.
Manual tuning:
Press the TUNING/TIME button as many times as required to tune in to the de-
sired station.
Auto tuning:
When the TUNING/TIME button is pressed for more than 0.5 seconds, scanning will
start automatically and the tuner will stop at the first receivable broadcast station.
Notes:
When radio interference occurs, auto scan tuning may stop automatically at
that point.
Auto scan tuning will skip weak signal stations.
To stop the auto tuning, press the TUNING/TIME button again.
When an RDS (Radio Data System) station is tuned in, the frequency will be displayed
first, and then the RDS indicator will light. Finally, the station name will appear.
Full auto tuning can be achieved for RDS stations "ASPM", see page 25.
To receive an FM stereo transmission:
Press the TUNER (BAND) button to display the "ST" indicator.
" " will appear when an FM broadcast is in stereo.
FM stereo mode indicator
FM stereo receiving indicator
If the FM reception is weak, press the TUNER (BAND) button to extinguish the "ST"
indicator. The reception changes to monaural, and the sound becomes clearer.
After use:
Press the ON/STAND-BY button to enter the power stand-by mode.
02/1/9
CD-DP900H(H)_2.fm
CD-DP900H
ENGLISH
E-16
Sound control (See page 11.)
1
2
3
4
5
6
7
8
Advertisement
Table of Contents
