Opening Lists With The Message Key; Using A Handset As A Room Monitor - Siemens Gigaset S68H User Manual

Opening lists with the
message key
An advisory tone sounds as soon as a new
message arrives in a list. The message key
f flashes (it goes off when the key is
pressed). In idle status, the display shows
an icon for the new message.
If you press the message key f, you
access the lists that contain new mes-
sages.
Using a handset as a
room monitor
If the room monitor is activated, a previ-
ously saved destination number is called
as soon as a set noise level is reached. You
can save an internal or external number in
your handset as the destination number.
The room monitor call to an external
number stops after around 90 seconds.
The room monitor call to an internal
number (handset) stops after approx. 3
minutes (depending on the base station).
While the room monitor is activated, all
keys are locked except the end call key.
The handset's speaker is muted.
When the room monitor is activated,
incoming calls to the handset are indi-
cated without a ringer tone and are only
shown on the screen. The display and key-
pad are not illuminated and advisory
tones are also turned off.
If you accept an incoming call, the room
monitor mode is suspended for the dura-
tion of the call, but the function remains
activated.
If you deactivate then reactivate the hand-
set, the room monitor mode remains acti-
vated.

Using a handset as a room monitor

Caution!
– You should always check the operation
of the room monitor before use. For
example, test its sensitivity. Check the
connection if you are diverting the room
monitor to an outside number.
– When the function is switched on the hand-
set's operating time is severely reduced. If
necessary, place the handset in the charg-
ing cradle. This ensures that the batteries
do not run down.
– Ideally the handset should be positioned 1
to 2 metres away from the baby. The micro-
phone must be directed towards the baby.
– The connection to which the room monitor
is diverted must not be blocked by an acti-
vated answer machine.
Activating the room monitor and
entering the number to be called
¢ ¢
v í
Room Monitor
¤
Change multiple line input:
Room M.:
Select On to activate.
Call to:
External number: Select the number
from the directory (press display key
Ò
) or enter it directly. Only the
last 4 digits are displayed.
Internal number:
¢ ¢
s (select handset or
§OK§
if all registered handsets are to be
¢
called) .
§OK§
Level:
Set noise level sensitivity
¤
Press to save the settings.
§Save§
¢
INT
§Options§
Call All
(Low or High).
17