Advanced Cd Or Mp3/Wma Disc Playback - Sharp XL-DH320NH Operation Manual

Listening to a CD or MP3/WMA disc
(continued)
■ Disc playback
1
Press the ON/STAND-BY button to turn the power on.
2
Press the CD button on the remote control or FUNCTION
button repeatedly on the main unit to select CD function.
3
Press the OPEN/CLOSE button to open the disc tray.
4
Place the disc on the disc tray, label side up.
5
Press the OPEN/CLOSE button to close the disc tray.
6
Press the / button to start playback. After the last track is
played, the unit will stop automatically.
Caution:
● Do not place two discs in one disc tray.
● Do not play discs of special shapes (heart, octagon, etc). It
may cause malfunctions.
● Do not push the disc tray whilst it is moving.
● If the power fails whilst the tray is open, wait until the power
is restored.
● If TV or radio interference occurs during CD operation, move
the unit away from the TV or radio.
● Be sure to place 8 cm (3") disc in the middle of the disc tray.
● Due to the structure of the disc information, it takes longer to
read an MP3/WMA disc than a normal CD (approximately 20
to 90 seconds).
Notes for CD or MP3/WMA disc:
● When the end of the last track is reached during fast forward,
"END" will appear on the display and CD operation will be
paused. When the beginning of the first track is reached
during fast reverse, the unit will enter the playback mode
(only for CD).
● Rewritable multi-session discs with unfinished writing, can
still be played.
■ Various disc functions
Function Main Remote
unit control
Play
Stop
Pause
Track ____
up/
down
____
Fast
forward/
reverse
Operation
Press in the stop mode.
Press in the playback
mode.
Press in the playback
mode. Press the /
button to resume
playback from the
paused point.
Press in the playback or
stop mode.
If you press the button in
the stop mode, press the
/ button to start the
desired track.
Press and hold down in
the playback mode.
Release the button to
resume playback.
E-9
Advanced CD or MP3/WMA disc
playback
CD
USB
■ Direct track search
By using the Direct Search buttons, the desired tracks on the
current disc can be played.
Use the Direct Search buttons on the remote control to
select the desired track whilst playing the selected disc.
● The Direct Search buttons allow you to select up to number 9.
● When selecting number 10 or higher, use the "10+" button.
A. For example, to choose 13
1
Press the "10+" button once.
2
Press the "1" button.
3
Press the "3" button.
B. For example, to choose 130
1
Press the "10+" button twice.
2
Press the "1" button.
3
Press the "3" button.
4
Press the "0" button.
Notes:
● A track number higher than the number of tracks on the disc
cannot be selected.
● During random play, direct search is not possible.
To stop playback:
Press the (CD ) button.
■ Repeat play
Repeat play can play one track, all tracks or a programmed
sequence continuously.
To repeat one track:
Press the PLAY MODE button repeatedly until "1-REPEAT"
appears. Press the / button.
To repeat all tracks:
Press the PLAY MODE button repeatedly until "ALL REPEAT"
appears. Press the / button.
To repeat desired tracks:
Perform steps 1 - 5 in "Programmed play" section on page 10 and
then press the PLAY MODE button repeatedly until "ALL
REPEAT" appears.
To cancel repeat play:
Press the PLAY MODE button repeatedly until "NORMAL"
appears and " " disappears.
Selected track number