Listening To The Radio - Sharp XL-MP9H Operation Manual

Listening to the radio

You can use buttons on the remote control instead of the operation
lever.
1
Press the ON/STAND-BY button to turn the power on.
2
Press the FUNCTION button until "FM" or "AM" appears on
the display.
When operating with the remote control, press the TUNER
(BAND) button to select "FM" or "AM".
3
Press the TUNING ( or ) button to tune in to the desired
station.
Manual tuning:
Press the TUNING button as many times as required to tune in
to the desired station.
Auto tuning:
When the TUNING button is pressed for more than 0.5 sec-
onds, scanning will start automatically and the tuner will stop at
the first receivable broadcast station.
Notes:
! When radio interference occurs, auto scan tuning may stop auto-
matically at that point.
! Auto scan tuning will skip weak signal stations.
! To stop the auto tuning, press the TUNING button again.
! When an RDS (Radio Data System) station is tuned in, the fre-
quency will be displayed first, and then the RDS indicator will
light. Finally, the station name will appear.
! Full auto tuning can be achieved for RDS stations "ASPM", see
page 22.
To receive an FM stereo transmission:
Press the FUNCTION button to display the "ST" indicator.
! " " will appear when an FM broadcast is in stereo.
! If the FM reception is weak, press the FUNCTION button to extin-
guish the "ST" indicator. The reception changes to monaural, and
the sound becomes clearer.
FM stereo receiving indicator
FM stereo mode indicator
05/5/23 XL-MP9H(H)E2.fm
XL-MP9H
ENGLISH
8
E-18
TINSZA058SJZZ