Table of Contents
Advertisement
Preparation for video CD playback
XL-HP404V
ENGLISH
! Adjusting the TV and VCR
The TV and VCR input varies according to the connection method.
Be sure to make the settings correctly. (Then, follow the playback
procedure on page 18 to check the settings.)
<For TV sets with a video input socket>
Set the input selector
to AUX.
Set the TV/VCR selector
to VCR.
<For TV sets without a video input socket>
E-17
! Selecting the video output format
Video CD is recorded in PAL or NTSC format.
Select the video output format (NTSC or PAL) according to your TV
or VCR.
To select the video output format:
Whilst in the stop mode, press the PAL/NTSC button.
Each time this button is pressed, the format will change in the fol-
lowing order:
Set the input selector
to VCR.
Notes:
" When you watch a PAL disc in the NTSC mode or an NTSC disc
TV
in the PAL mode, the vertical size of the picture will not be modi-
fied.
" If a multi-mode TV is equipped with an input selector switch, set
the switch to "MULTI MODE". For the details, refer to the TV
operation manual.
" Do not change the video output format during playback. If you do,
the picture signal may not be output properly.
VCR
" Picture may be distorted when the setting is switched. This is not
the malfunction of the unit.
" If the unit is set to the stand-by mode or the function is changed
from CD/VIDEO CD to another, the setting will change back to
the state at the factory shipment (default setting). The setting
details vary depending on areas.
" Whilst playing an audio CD or MP3 disc, you cannot switch to
NTSC or PAL.
04/2/9
NTSC
XL-HP404V(Z)E2.fm
TINSZA059AWZZ
1
PAL
Advertisement
Table of Contents
