Table of Contents
Advertisement
Radio
E
N
G
L
I
How to listen to the radio
S
H
q
5
Mode Selection (SOURCE)
Press [SOURCE] to change to the radio mode.
w
Band
Press [BAND] to change the
bands.
Band
FM1
CQ-FX323W
FM2
TUNE
TRACK
FM3
AM
e
r
Manual Tuning
Press
MONO : Noise is significantly decreased when weak signals are received
[}TUNE] : Higher frequency.
[{TUNE] : Lower frequency.
LOCAL : Only strong signals of stations are detected in seek tuning, while at
Seek Tuning
FM broadcasts
Press and hold
Press and hold [¡] (MONO/LOC) to
[}TUNE] : Higher frequency.
change the mode.Release when at the
[{TUNE] : Lower frequency.
desired point.
Tuning will automatically stop when
the signals of the next broadcast
station are received.
10
CQ-FX323W
CQ-FX421/FX321N
Radio
Cassette Tape Player
(When a tape is inserted)
CD changer control
(When a CD Changer is connected)
OPEN
OPEN
OPEN
CASSETTE RECEIVER WITH CHANGER CONTROL
LEVEL
DIMMER
CLOCK
super bright display with level meters
MUTE
DISC
RANDOM
SCAN
REPEAT
1
MTL
2
NR
3
TPS
4
5
B·S REP
6
LOUD
APM
Stereo indicator lights
when FM stereo broad-
casting is received
Mono/Local Selection (MONO/LOC)
from an FM broadcast station.
the LOCAL OFF setting, relatively weak signals are also detected.
AM broadcast
Press and hold [¡] (MONO/LOC)
to switch LOCAL mode on and off.
(Default)
MONO OFF / LOCAL OFF
LOCAL OFF
MONO ON / LOCAL OFF
LOCAL ON
MONO ON / LOCAL ON
MONO OFF / LOCAL ON
LOCAL
MONO
MONO/LOCAL indicator
[BAND]
[}TUNE]
[{TUNE]
Preset Memory
Up to 6 stations each can be stored in the FM1, FM2, FM3
and AM preset band selections.
q
Band
Press [BAND] to select a desired band.
DISP
w
Manual Preset Memory
q Use manual or seek tuning to find a station.
(a
page 10)
w Press and hold one of the preset buttons [1] to [6]
until the display blinks once.
Preset Number
Auto Preset Memory (APM)
Press [APM].
¡The 6 stations,with good reception will be automati-
cally saved in the memory under preset 1 to 6.
¡Once set, the preset stations are sequentially
scanned for 5 seconds each.
e
Tuning in a Preset Station
(Default)
Press the corresponding preset button [1] to [6] to
tune in a preset station.
Note: You can change the memory presetting by
repeating the above procedure.
Caution: To ensure safety, never attempt to preset
stations while you are driving.
Clock
Clock Setting
CASSETTE RECEIVER WITH CHANGER CONTROL
CQ-FX323W
TUNE
TRACK
super bright display with level meters
MUTE
DISC
RANDOM
SCAN
REPEAT
1
MTL
2
NR
3
TPS
4
5
B·S REP
6
[1] to [6] (Preset buttons)
Initial Time
q Press [DISP](CLOCK).
"ADJUST" appears on the display
(a
Page 10)
w Press and hold [DISP](CLOCK) for more than 2
seconds."12" blinks,and the time setting mode is
activated.
e Press [ } TUNE] or [{TUNE] to set the hour.
r Press [DISP](CLOCK) to proceed with the
minutes setting.
t Press [}TUNE] or [{TUNE] to set the minute.
y Once the time has been set, press [DISP](CLOCK).
Notes:
¡The clock system is 12-hours.
¡Press [}TUNE] or [{TUNE] for more than 0.5
seconds to change numbers on the display in
sequence.
¡The [DISP](CLOCK) button will not work while the
CD Changer is set to the scan play mode.Cancel the
scan play mode before pressing [DISP](CLOCK).
E
N
G
L
I
S
H
6
OPEN
OPEN
OPEN
LEVEL
DIMMER
CLOCK
[DISP]
DISP
(CLOCK)
LOUD
APM
[APM]
12:00
10:00
10:00
10:35
10:35
11
CQ-FX323W
Advertisement
Table of Contents
