Table of Contents
Advertisement
Electrical Connections
E
N
G
L
I
Cable Wiring Diagram
S
H
Example : Connection with CD Changer CX-DP88N (Option).
15
RCA Cord
Antenna
Cassette Receiver
CQ-FX323W
Stereo power
amplifier
(L) (White)
(Rear)
(R) (Red)
Stereo power
amplifier
(L) (White)
(Front)
(R) (Red)
Speakers
Rear Left +
(Green)
Rear Left –
(Green w/black stripe)
Front Left +
(White)
Front Left –
(White w/black stripe)
Front Right +
(Gray)
Front Right –
(Gray w/black stripe)
Rear Right +
(Violet)
Rear Right –
(Violet w/black stripe)
20
CQ-FX323W
CQ-FX323W
Changer Control DIN Cord
(L) (White)
CH•C-IN
(R) (Red)
CD Changer
Control Connector
Preamp out Connector
(Pre-out) Front
Preamp out Connector
(Pre-out) Rear
L(White)
R(Red)
yPower
Connector
Optional
RCA cord (Audio)
For two speakers
Insulate unused speaker cords
with vinyl tape
CD Changer
CX-DP88N
(option)
Ground Lead
To a clean, bare
metallic part of
the car chassis
Extension Cord
(DIN/BATT/RCA/GND)
(Supplied for an optional
CD Changer)
(Black)
(Yellow)
Fuse (3A)
Battery Lead
To the car battery,
continuous +12V DC
Keep the vinyl cap covered
for insulation
if this is not used.
(Black)
ACC
(Red)
Resistor (1kΩ)
(Dark Blue)
Fuse (15A)
BATTERY 15A
(Yellow)
Cautions:
¡This unit is designed for use in a car having a
12-volt negative ground battery system.
¡To prevent damage to the unit, be sure to follow
the connection diagram below.
¡Strip about 5 mm of the lead ends for connec-
tion.
¡Do not insert the power connector into the unit
until the wiring is completed.
¡Be sure to insulate any exposed wires to pre-
vent short circuiting with the car chassis.
Bundle all cables, and prevent cable terminals
from touching any metal parts.
¡This unit can be connected to an optional CD
Changer (CX-DP9061EN, CX-DP88N, CX-
DP1212N, CX-DP801EN, CX-DP880N) and
optional extension cord.
¡For details consult your shop where you pur-
chased this unit.
¡For connection to a CD Changer, refer to the
operating instructions of the CD Changer (CX-
DP9061EN, CX-DP88N, CX-DP1212N, CX-
DP801EN, CX-DP880N).
Ground Lead (Black)
To a clean, bare metallic part of the car chassis
Power Lead (ACC or IGN) (Red)
To ACC power, +12 V DC
Motor Antenna Relay Control (Dark blue)
(To the auto antenna control power load of the
car.)(Max.500 mA)
This lead is not intended for use with a switch actuat-
ed Power antenna.
Amp. Relay Control Power Lead
This lead is for connection to a Panasonic power
amplifier.
Battery Lead (Yellow)
To the car battery, continuous +12 V DC
CQ-FX323W
E
N
G
L
I
S
H
16
1
21
Advertisement
Table of Contents
