Panasonic AW‑HE60HN Operating Instructions Manual page 37

Parts and their functions
9 LAN connector for IP control [LAN ACT/LINK]
This LAN connector (RJ45) is connected when exercising
IP control over the unit from an external device.
Use a cable with the following specifications for the
connection to the LAN connector:
When connecting through a hub:
LAN cable* (category 5 or above, straight cable), max.
100 meters [328 ft]
When a hub is not used:
LAN cable* (category 5 or above, crossover cable),
max. 100 meters [328 ft]
*: Use of an STP (shielded twisted pair) cable is
recommended.
 Anti-theft wire mounting hole
Use this hole to attach the wire bracket.
 HDMI connector [HDMI] (AW-HE60H only)
This is the HDMI video output connector.
 Hole used to secure cable cover
Use the screw provided to secure the cable cover.
 MULTI-I/F connector [MULTI-I/F]
This is the camera's HD/SD component video signal,
composite video signal and camera's control signal
connector.
Use the multi-interface cable purchased separately or a
cable with the DX40M-20P (made by Hirose) connector
specifications as the connecting cable.
Pin
10A 1A
No.
1A Y OUT
1B Y GND
2A Pb OUT
10B 1B
2B Pb GND
p  The above figure
3A Pr OUT
shows the pin
3B Pr GND
layout of the
4A VIDEO OUT*
connector on the
4B VIDEO GND*
camera as seen
from the outside.
5A TALLY
5B T GND
*: These signals are not output
during IP video output.
 DC IN connector [12V
Connect the AC adaptor supplied with the unit to this
connector to supply the DC 12 V voltage to the unit.
 Cable clamp
This is used to hold the cable connection to the DC IN
connector and prevent it from becoming disconnected.
(continued)
Pin
Signal name Signal name
No.
6A RX+_IN
6B RX–_IN
7A TX+_IN
7B TX–_IN
8A GND
8B GND
9A RX+_OUT
9B RX–_OUT
10A TX+_OUT
10B TX–_OUT
IN ]
 IR ID switches [IRID]
[CAM1] [CAM2]
These are used to select the ID of the wireless remote
control (optional accessory).
The IR ID switch settings "CAM1" to "CAM4" correspond
to the [CAM1] to [CAM4] buttons on the wireless remote
control.
 Square holes (2) for cable cover tabs
The tabs on the two sides of the cable cover are fitted into
these holes.
 SYNC IN connector [EXT SYNC IN]
(AW-HE60S only)
This is the external sync signal input connector.
This unit supports the BBS (Black Burst Sync) signal as
the external sync signal.
 SDI OUT connector [HD/SD SDI OUT]
(AW-HE60S only)
This is the SDI video signal output connector.
 Threaded hole (thread: 1/4-20UNC, ISO1222
[6.35 mm]) for mounting the camera
Use this hole when mounting the camera on a tripod, etc.
 Service switches
SW1 SW2 SW3 SW4
ON
OFF
The camera is used with all the switches at the OFF
setting.
[CAM3] [CAM4]
SW5 SW6 SW7 SW8
37