Lopi Endeavor Owner's Manual page 37

Attach the included
gasket to all four top
edges of the air boot.
Attach gasket to the bottom
edge of the air boot.
Bottom of Stove
5-1/8"
8-7/8"
Floor (and hearth)
Use a
screwdriver to
pry out the
knock-out (if
applicable).
Attach the air boot with
the two screws included
with the kit.
1/4" Nutdriver
Use the included screws to attach
the two telescoping portions of air
boot together. The included drill bit
should be used to drill the hole.
Make sure the air boot is expanded
to the correct size before drilling.
9/64" Drill Bit
5/16" Nutdriver
The hole in the floor (and hearth)
must be a minimum 16 square
inches. It should be 1/2" smaller
than the footprint of the air boot in
each dimension to allow for the
gasket to seal.