Welder Features - Chicago Electric 66787 Set Up And Operating Instructions Manual

wEldEr FEaturES

1. Electrode holder (8):
Electrode Holder Cable to the POSI-
TIVE Terminal located at the front of
the Welder. (See Figure a.)
2. Ground clamp (9):
Ground Clamp Cable to the NEGATIVE
Terminal located on the front of the
Welder. (See Figure a.)
3. potentiometer dial (4):
clockwise or counterclockwise to regu-
late the welding current (from 10 to 130
amps). (See Figure B.)
4. Green "power on" light (5):
illuminated, indicates the Welder is
receiving electrical power and is ready
for use. (See Figure B.)
5. Yellow "overheating" light (5):
When illuminated, indicates overheat-
ing caused by an excessively intense
duty cycle. In this case, stop welding
and wait until the welder has cooled
down. The welder will automatically
restart after the yellow "overheating"
light turns off.(See Figure B.)
6. Fan (14): The Fan must operate con-
tinuously when operating the Welder to
prevent the unit from overheating.
(See Figure c.)
7. power Switch (16):
must illuminate before welding opera-
tions can begin.
(See Figure c.)
8. tig welder torch
SKU 66787 For technical questions, please call 1-800-444-3353.
Connect the
Connect the
Turn the Dial
When
The Power Switch
REV 09h
Page 10