Inspecting Idling Speed - Yamaha F9.92D Owner's Manual

2. Unscrew the filter cup, catching any
spilled fuel in a rag.
3. Remove the filter element, and wash it in
solvent. Allow it to dry. Inspect the filter
element and O-ring to make sure they
are in good condition. Replace them if
necessary. If any water is found in the
fuel, the Yamaha portable fuel tank or
other fuel tanks should be checked and
cleaned.
2
4
1
1. Filter cup
2. Filter element
3. Filter housing
4. O-ring
4. Reinstall the filter element in the cup.
Make sure the O-ring is in position in the
cup. Firmly screw the cup onto the filter
housing.
5. Attach the filter assembly to the bracket
so that the fuel hoses are attached to the
filter assembly.
6. Run the engine and check the filter and
lines for leaks.
EMU29040

Inspecting idling speed

EWM00450
WARNING
Do not touch or remove electrical parts
G
when starting or during operation.
Keep hands, hair, and clothes away
G
from the flywheel and other rotating
parts while the engine is running.
2-hp models: The propeller rotates
G
whenever the engine is running. Do not
move the throttle control lever from the
start position during warm-up. The boat
could unexpectedly start to move,
which could result in an accident.
ECM00490
CAUTION:
This procedure must be performed while
the outboard motor is in the water. A
flushing attachment or test tank can be
used.
3
A diagnostic tachometer should be used for
this procedure. Results may vary depending
on whether testing is conducted with the
flushing attachment, in a test tank, or with the
ZMU02079
outboard motor in the water.
1. Start the engine and allow it to warm up
fully in neutral until it is running smooth-
ly.
2-hp model: Warm the engine with the
throttle in the start position or less. If the
outboard is mounted on a boat, be sure
the boat is tightly moored.
NOTE:
Correct idling speed inspection is only possi-
ble if the engine is fully warmed up. If not
warmed up fully, the idle speed will measure
higher than normal. If you have difficulty ver-
ifying the idle speed, or the idle speed re-
quires adjustment, consult a Yamaha dealer
or other qualified mechanic.
2. Verify whether the idle speed is set to
specification. For idle speed specifica-
tions, see page 48.
Maintenance
62