Depth Of Cut Adjustment; Miter Cuts - Chicago Electric 1624 Set Up And Operating Instructions Manual

VISE STOP (#69) to the desired posi-
tion. Tighten the BOLTS.
3. Raise the VISE LEAD SCREW RE-
LEASE HANDLE (#89) and slide
the VISE FACE (#67) forward until it
contacts the stock.
4. Lower the RELEASE HANDLE
so that it rests against the LEAD
SCREW (#81). Turn the VISE HAN-
DLE (#92) to tightly clamp the stock.

miter Cuts

1. Position stock as detailed in Step 1 of
Vise Assembly Operation, above.
2. Position the VISE STOP (#69) as
detailed in Step 2. Before tightening
the BOLTS (#68), position the VISE
STOP to the desired angle (from –30°
to +45°).
3. Advance the VISE FACE (#67) as de-
tailed in Steps 3 & 4. The FACE will
adjust to the angle of your stock.
SKU 1624 for technical questions, please call 1-800-444-3353.

depth of Cut adjustment

set Bolt
Figure 4 -- Adjusting Depth of Cut
1. Loosen the Set Nut on the Depth Ad-
justment Bolt as shown in Figure 4.
2. Raise or lower the Depth Adjustment
Bolt as necessary to obtain the de-
sired depth of cut.
depth
adjustment
Bolt
Page 8