Fitting The Steel Bracelet; Removing The Steel Bracelet - TAG Heuer 2000 AQUAGRAPH User Manual

* F i t t i n g a n d r e m o v i n g
s t e e l a n d r u b b e r b r a c e l e t s

Fitting the steel bracelet

You have (fig. 8):
– 2 case attachments
– 2 bars
– 1 bracelet with diver's extension
– 1 tool
Take the case attachment, place it on the
bracelet section (1st link), pass the bar
through the case attachment and the first
link. Grasp the watch and turn it over; the
watch glass must now face downwards.
With the watch in this position, compress
one pin of the bar by means of the tool
and tilt the case attachment so that the
compressed pin rests in the space
between the horns.
Proceed in the same way with the second
pin; then press the case attachment so that
the bar pins notch into the holes provided
for them.
* For owners of the diving kit
fig. 8 Important: Always make sure that the two
bar pins are correctly fitted. Otherwise you
may lose your watch.
The section of the bracelet with the diver's
extension must always be positioned on
the 12 o'clock side (fig. 9).

2. Removing the steel bracelet

Use the tool; place the cylindrical end of
the tool in a hole on the side of the case;
compress a bar pin and press the case
Case attachment
Bar attachment from the watch crystal side
Bracelet
(fig. 10).
Tool
Pin
Proceed in the same way on the other side;
Horn
the bracelet can be removed.
Once the bracelet has been removed, you
have:
– 2 case attachments
– 2 bars
– 1 bracelet
fig. 9
15
Diver's extension
fig. 10
Tool