Using The Remote Controller (Rm-Rk50) - JVC KD-A805 Instructions Manual

r
• Return to the previous menu.
• iPod FRONT/iPod REAR: Switch the
setting between <Headunit Mode> and
<iPod Mode> * 7
[Hold].
• BT FRONT/BT REAR (Audio): Pause
playback.
t • Control the volume *
• Confirm the selection [Press] .
• FM/HD RADIO: Enter SSM preset mode
[Hold] .
• CD/USB FRONT/USB REAR/iPod
FRONT/iPod REAR: Pause/resume
playback * 2
[Press].
• BT FRONT/BT REAR (Audio): Resume
playback * 2
[Press].
• CD/USB FRONT/USB REAR/iPod
FRONT/iPod REAR/BT FRONT (Audio) *
BT REAR (Audio) *
mode [Hold].
y
Remote sensor
u
AUX (auxiliary) input jack

Using the remote controller (RM-RK50)

Installing the lithium coin battery (CR2025)
For USA-California Only:
This product contains a CR Coin Cell Lithium Battery
which contains Perchlorate Material—special
handling may apply.
See www.dtsc.ca.gov/hazardouswaste/perchlorate
2
or select items [Turn].
3
/CD-CH: Enter playback
* 1
Also known as "Control dial" in this manual.
* 2
You can still adjust the volume during pause when
the selected source is CD/USB FRONT/USB
REAR/iPod FRONT/iPod REAR/BT FRONT/
BT REAR/iPod.
Before resume playback, check to be sure that you
have not raise the volume level too much.
* 3
For Bluetooth devices that support AVRCP 1.3.
* 4
When the HD Radio tuner box is connected, the
built-in tuner of this unit will be disabled. To listen
to the HD Radio broadcast, refer to "Listening to the
radio" on pages 9 and 10. For more features, see
pages 19 and 20.
* 5
You cannot select these sources if they were disabled
in the <SET UP> menu (see <Source Select> in
"Menu operations" on page 33).
3 * 6
/ You cannot select these sources if they are not ready
or not connected.
* 7
You can use this function only when <iPod Mode>
is available for the connected iPod (see pages 24 and
41).
Caution:
• Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
• Battery shall not be exposed to excessive heat such as
sunshine, fire, or the like.
If the effectiveness of the remote controller
decreases, replace the battery.
Before using the remote controller:
• Aim the remote controller directly at the remote
sensor on the unit.
• DO NOT expose the remote sensor to bright light
(direct sunlight or artificial lighting).
Remote sensor
Continued on the next page
OPERATIONS 7