Table of Contents
Advertisement
r
• Return to the previous menu.
• iPod FRONT/iPod REAR: Switch the
setting between <Headunit Mode> and
<iPod Mode> *
6
[Hold].
• BT FRONT/BT REAR (Audio): Pause
playback.
t
• Control the volume *
• Confirm the selection [Press] .
• FM: Enter SSM preset mode [Hold] .
• CD/USB FRONT/USB REAR/iPod
FRONT/iPod REAR: Pause/resume
playback *
2
[Press].
• BT FRONT/BT REAR (Audio): Resume
playback *
2
[Press].
• CD/USB FRONT/USB REAR/iPod
FRONT/iPod REAR/BT FRONT (Audio) *
BT REAR (Audio) *
mode [Hold].
y
Remote sensor
u
AUX (auxiliary) input jack
Using the remote controller (RM-RK50)
Installing the lithium coin battery (CR2025)
Caution:
• Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
• Battery shall not be exposed to excessive heat such as
sunshine, fire, or the like.
If the effectiveness of the remote controller
decreases, replace the battery.
2
or select items [Turn].
3
/CD-CH: Enter playback
1
*
Also known as "Control dial" in this manual.
*
2
You can still adjust the volume during pause when the
selected source is CD/USB FRONT/USB REAR/
iPod FRONT/iPod REAR/BT FRONT/BT
REAR/iPod.
Before resume playback, check to be sure that you
have not raise the volume level too much.
*
3
For Bluetooth devices that support AVRCP 1.3.
*
4
You cannot select these sources if they were disabled
in the <SET UP> menu (see <Source Select> in
"Menu operations" on page 29).
*
5
You cannot select these sources if they are not ready
or not connected.
*
6
You can use this function only when <iPod Mode>
is available for the connected iPod (see pages 20 and
3
/
37).
Before using the remote controller:
• Aim the remote controller directly at the remote
sensor on the unit.
• DO NOT expose the remote sensor to bright light
(direct sunlight or artificial lighting).
Remote sensor
Continued on the next page
OPERATIONS
7
Hide quick links:
Advertisement
Table of Contents
