Recalling Equalizer Curves - Pioneer DEH-80PRS Operation Manual

Operating this unit
5 Turn M.C. to select cut-off frequency.
50—63—80—100—125—160—200 (Hz)
Only frequencies higher than those in the se-
lected range are output from the front speak-
ers.
6 Turn LEVER to adjust the output level
of the front speakers.
0 to –24 is displayed as the level is increased
or decreased.
Setting the high pass filter for rear
speakers
1 Use M.C. to select R.HPF 1.
Refer to Introduction of audio adjustments on
page 20.
2 Turn LEVER to select slope.
–12— –6—Pass (dB/oct.)
# If you set the slope Pass (0 dB/oct.), the audio
signal bypasses the filter, so the filter does not
have an effect.
3 Press /DISP to display the upper tier.
4 Use M.C. to select R.HPF 2.
Refer to Introduction of audio adjustments on
page 20.
5 Turn M.C. to select cut-off frequency.
50—63—80—100—125—160—200 (Hz)
Only frequencies higher than those in the se-
lected range are output from the rear speak-
ers.
6 Turn LEVER to adjust the output level
of the rear speakers.
+6 to –24 is displayed as the level is increased
or decreased.
Using the auto-equalizer
The auto-equalizer is the equalizer curve cre-
ated by auto TA and EQ (refer to Auto TA and
EQ (auto-time alignment and auto-equalizing)
on page 29).
You can turn the auto-equalizer on or off.
1 Use M.C. to select A.EQ in the audio
function menu.
Refer to Introduction of audio adjustments on
page 20.
# If auto TA and EQ has not been carried out,
Please set Auto EQ appears. This indicates that
you cannot turn this function on.
2 Press M.C. to turn the auto-equalizer
on.
Auto EQ ON appears in the display.
# To turn auto-equalizer off, press M.C. again.

Recalling equalizer curves

You can adjust the equalization to match the
car's interior acoustic characteristics as de-
sired.
There are seven stored equalizer curves which
you can easily recall at any time. Here is a list
of the equalizer curves.
Display Equalizer curve
Super bass
Super bass
Powerful Powerful
Natural Natural
Vocal Vocal
Flat
Flat
Custom1 Custom 1
Custom2 Custom 2
! Custom1 and Custom2 are adjusted equal-
izer curves that you create. Adjustments
can be made with a 16-band graphic equal-
izer.
! When Flat, no changes are made to the
sound. You can check the effects of the
equalizer curves by switching alternatively
between Flat and another equalizer curve.
% Press EQ/DISP OFF to select the equali-
zer.
Press EQ/DISP OFF repeatedly to switch be-
tween the following equalizers:
Powerful—Natural—Vocal—Flat—Custom1
—Custom2—Super bass
Section
02
27
En