Troubleshooting ... 14 When unpacking, check to make sure the product is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at the number on the cover of this manual as soon as possible.
Do not overreach. Keep proper footing and balance at all times. Do not reach over or across running machines or air hoses. For technical questions, please call 1-800-444-3353; SKU 43760 Troubleshooting section at end of manual. Specifications 20-55 PSI, 55 PSI Max.
Page 4
Use of any other parts will void the warranty. Only use accessories intended for use with this tool. Approved accessories are available from Harbor Freight Tools. Do not operate tool if under the influence of alcohol or drugs. Read warning labels if taking prescription medicine to determine if your judgement or reflexes are impaired while taking drugs.
Page 5
For technical questions, please call 1-800-444-3353; SKU 43760 Troubleshooting section at end of manual. Page 5...
For best service you should incorporate a regulator and inline filter, as shown in the diagram above. Hoses, couplers, regulators, and filters are all available at Harbor Freight Tools. Note: Compressor pumps discharge condensed water, oil, or other contaminants along with the compressed air.
If it appears to thin, add a very small amount of thinner (not included). BE CAREFUL when thinning. Proceed slowly, adding very minimal amounts. NEVER exceed the manufacturer’s thinning recommendations. For technical questions, please call 1-800-444-3353; SKU 43760 Troubleshooting section at end of manual. Conventional HVLP...
FIGURE 1 on page 6). By turning it counterclockwise (all the way open), the pattern will flatten. Turn the Pattern Control Knob (14) clockwise for a round pattern. See FIGURE 4 below. Flat/Open For technical questions, please call 1-800-444-3353; SKU 43760 Troubleshooting section at end of manual. Horizontal Fan Air Cap Vertical Fan...
Page 9
(you see globs of paint), close down the Fluid Control Knob (15) slowly, checking the mixture after each adjustment. See FIGURE 5 below. Too Coarse (Tighten) For technical questions, please call 1-800-444-3353; SKU 43760 Troubleshooting section at end of manual. FIGURE 5 Correct Too Fine (Loosen)
Clean out the gun thoroughly after EVERY use, according to the instructions found on the next page. For technical questions, please call 1-800-444-3353; SKU 43760 Troubleshooting section at end of manual. Techniques FIGURE 6...
Disposal: After cleaning your Spray Gun, properly dispose of your cleaning solutions according to the solution manufacturer’s direction and local hazardous waste standards. For technical questions, please call 1-800-444-3353; SKU 43760 Troubleshooting section at end of manual. Maintenance SOLVENT SELECTION and disposing of used solvent.
THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO. NOTE: Some parts are listed and shown for illustration purposes only and are not available individually as replacement parts. For technical questions, please call 1-800-444-3353; SKU 43760 Troubleshooting section at end of manual. Parts List REV 10/03; 08/05...
2. Holes on one side of the Air cap are plugged. (Clean the Air cap with a nonmetallic point.) If the steps above do not solve the problem or if the repairs involved are too SKU 43760 For technical questions, please call 1-800-444-3353.
Page 15
1. Packing Nut loose Packing Nut (22) 2. Packing worn or dry If the steps above do not solve the problem or if the repairs involved are too SKU 43760 For technical questions, please call 1-800-444-3353. Troubleshooting (continued) complex, contact a qualified technician.