2-3.5 Cmos Clearing (Jp5); 2-3.6 Power On - SOYO SY-6VBA133-B User Manual

Hardware Installation

2-3.5 CMOS Clearing (JP5)

In some cases the CMOS memory may contain wrong data, follow the
steps below to clear CMOS memory.
1. Clear the CMOS memory by momentarily shorting pin 2-3 on jumper
JP5. This jumper can be easily identified by its white colored cap.
2. Then put the jumper back to 1-2 to allow writing of new data into
the CMOS memory.
CMOS
Clearing
JP5 Setting
Note: You must unplug the ATX power cable from the ATX power
connector when performing the CMOS Clear operation.

2-3.6 Power On

You have now completed the hardware installation of your Motherboard
successfully.
1. Turn the power on
2. To enter the BIOS Setup Utility, press the <DEL> key while the system
is performing the diagnostic checks,
Note: If you have failed to enter the BIOS, wait until the boot up
sequence is completed. Then push the RESET button and press
<DEL> key again at the beginning of boot-up, during diagnostic
checks.
Clear CMOS Data
Short pin 2-3 for
at least 5
seconds
to clear the
CMOS.
Retain CMOS Data
Short pin 1-2 to
retain the new
settings.
1 2 3
43
SY-6VBA133-B
1 2 3